Quality Statenville GA septic system installers do a number of examination, long before a unit gets put into the ground. A new unit will last decades, and possibly even generations, if it’s installed properly, but it can fall short instantaneously if it’s not. Additionally, all Statenville GA septic system installers must obtain a permit for them to carry out the install, and may will have to work with city or county officials to show that specific tests were done in order to proceed. These three assessments are essential first steps that should always be taken before any job or designs are done, and it may also be advantageous to do them before you acquire a property, so you could be assured that a tank and leach field will be allowed.
1. Pit
The pit test is relatively direct. During the course of this test, a hole is excavated and the soil is inspected to figure out its composition. A standard leach field is dependent on the soil’s composition to drain efficiently. If there is a lot of gravel or sand, your leach field should be capable to discharge the effluent (water) from the tank well, where the soil will finish cleaning it. If the soil has a lot of clay or rock, it won’t sink well, therefore a standard leach field will not be an alternative. If the location you’ve picked does not successfully pass the pit test, you may be able to select another site on your property or use an alternate type of drain field, like a mound system.
2. Perc
The perc, or percolation test, consists of digging a 14-inch deep hole, adding a 2-inch layer of sand or gravel, and then saturating it with water. The hole is typically left saturated for about two hours, and refilled as needed. After this, the hole is filled with 6 inches of water and observed for water drainage.
3. Visual
There are several things an inspector will check into visually. Most units are gravity-fed, so they don’t rely on electricity or pumps to shift effluent from the tank to the leach field. As a result of this, the incline of the ground is crucial. An inspector will also look for inclines that could feed excessive water into the leach field, as well as nearby bodies of water, the water table, and distance from the proposed unit to things like the home and wells.
Work with Quality Statenville GA Septic System Installers Today
Choosing the right layout, style of system, and evaluating the land properly, are all integral steps in making sure an install goes off without a hitch. Most significantly, these steps guarantee that the install is done correctly, so that a system provides many years of use without problems. If you’re prepping for an install, call Septic Tank Pros Valdosta GA. Our partner technicians are skilled and dedicated to quality, so you can be sure the job is done right. Call (229) 415-7780 right now.