Quality Sparks GA septic system installers do a great deal of examination, long before a unit gets put into the ground. A new unit will last many years, and possibly even generations, if it’s set up the right way, but it can break down instantly if it’s not. Furthermore, all Sparks GA septic system installers must secure a permit in order to carry out the install, and may need to work with city or county officials to show that specific tests were run in order to continue. These three assessments are necessary initial steps that should always be taken before any task or designs are done, and it may also be helpful to accomplish them before you purchase a property, so you can be assured that a tank and leach field will be permitted.
1. Pit
The pit test is very uncomplicated. During the course of this test, a hole is dug and the soil is examined to establish its structure. A standard leach field is reliant on the soil’s composition to drain successfully. If there is a lot of gravel or sand, your leach field should be ready to discharge the effluent (water) from the tank well, where the soil will finish cleaning it. If the soil has a considerable amount of clay or rock, it won’t sink well, therefore a conventional leach field will not be an alternative. If the location you’ve selected does not pass the pit test, you may be able to select another site on your house or use an alternate kind of drain field, such as a mound system.
2. Perc
The perc, or percolation test, requires excavating a 14-inch deep hole, adding a 2-inch layer of sand or gravel, and then saturating it with water. The hole is commonly left saturated for about two hours, and refilled as needed. After this, the hole is filled with 6 inches of water and observed for water drainage.
3. Visual
There are many things an inspector will investigate visually. The majority of units are gravity-fed, so they don’t rely upon electricity or pumps to move effluent from the tank to the leach field. Because of this, the incline of the ground is essential. An inspector will also seek out inclines that could feed excessive water into the leach field, as well as nearby bodies of water, the water table, and distance from the proposed unit to things like the home and wells.
Work with Quality Sparks GA Septic System Installers Now
Selecting the right configuration, style of system, and assessing the land properly, are all important procedures in making sure an install goes off without a hitch. Most importantly, these steps ensure that the install is done correctly, so that a system provides decades of use without issue. If you’re prepping for an install, call Septic Tank Pros Valdosta GA. Our partner professionals are knowledgeable and devoted to quality, so you can be sure the job is done right. Call (229) 415-7780 today.