Quality Riverside GA septic system installers do a lot of examination, long before a unit gets installed into the ground. A brand new unit will last decades, and possibly even generations, if it’s set up properly, but it can fail immediately if it’s not. On top of that, all Riverside GA septic system installers must acquire a permit in order to do the install, and may need to coordinate with city or county officials to show that a number of tests were performed in order to move on. These three evaluations are vital initial steps that should always be taken before any task or designs are done, and it may also be helpful to do them before you purchase a property, so you can be assured that a tank and leach field will be allowed.
1. Pit
The pit test is pretty direct. During the course of this test, a hole is excavated and the soil is examined to establish its structure. A typical leach field is reliant on the soil’s composition to drain effectively. If there is a bunch of gravel or sand, your leach field should be capable to discharge the effluent (water) from the tank well, where the soil will finish sanitizing it. If the soil has a considerable amount of clay or rock, it won’t drain well, consequently a conventional leach field will not be an option. If the location you’ve picked does not successfully pass the pit test, you may be able to choose another site on your home or use an alternate type of drain field, such as a mound system.
2. Perc
The perc, or percolation test, consists of digging a 14-inch deep hole, adding a 2-inch layer of sand or gravel, and then saturating it with water. The hole is typically left drenched for about two hours, and topped off as needed. After this, the hole is filled with 6 inches of water and observed for drainage.
3. Visual
There are several things an inspector will investigate visually. The majority of units are gravity-fed, so they don’t rely upon electricity or pumps to shift effluent from the tank to the leach field. As a result of this, the slope of the ground is essential. An inspector will also search for inclines that could feed excessive water into the leach field, as well as nearby bodies of water, the water table, and distance from the proposed unit to things like the home and wells.
Choose Quality Riverside GA Septic System Installers Now
Selecting the right layout, kind of system, and evaluating the land correctly, are all fundamental procedures in making sure an install goes off without a hitch. Most significantly, these steps ensure that the install is done properly, so that a system provides many years of use without problems. If you’re preparing for an install, contact Septic Tank Pros Valdosta GA. Our partner professionals are experienced and dedicated to quality, so you can be sure the job is done right. Call (229) 415-7780 now.