Quality Nashville GA septic system installers do a number of legwork, long before a unit gets put into the ground. A brand new unit will last many years, and possibly even generations, if it’s placed correctly, but it can fail instantly if it’s not. On top of that, all Nashville GA septic system installers must obtain a permit in order to do the install, and may need to partner with city or county officials to show that specific tests were run in order to progress. These three tests are necessary initial steps that should always be taken before any task or designs are done, and it may also be helpful to do them before you purchase a property, so you can be assured that a tank and leach field will be allowed.
1. Pit
The pit test is very straightforward. During this test, a hole is dug and the soil is inspected to determine its structure. A conventional leach field is reliant on the soil’s structure to drain successfully. If there is a lot of gravel or sand, your leach field should be able to discharge the effluent (water) from the tank well, where the soil will finish cleaning it. If the soil has a bunch of clay or rock, it won’t drain well, and so a standard leach field will not be an alternative. If the location you’ve chosen does not successfully pass the pit test, you may be able to choose another site on your home or use an alternate type of drain field, like a mound system.
2. Perc
The perc, or percolation test, involves excavating a 14-inch deep hole, adding a 2-inch layer of sand or gravel, and then filling it with water. The hole is normally left soaked for about two hours, and refilled as needed. Then, the hole is filled with 6 inches of water and observed for drainage.
3. Visual
There are numerous things an inspector will investigate visually. Most units are gravity-fed, so they don’t rely upon electricity or pumps to shift effluent from the tank to the leach field. As a result of this, the slope of the ground is crucial. An inspector will also seek out inclines that can feed excess water into the leach field, as well as nearby bodies of water, the water table, and distance from the proposed unit to things like the home and wells.
Hire Quality Nashville GA Septic System Installers Today
Picking the right design, kind of system, and assessing the land properly, are all integral steps in making sure an install goes off without a hitch. Most significantly, these steps ensure that the install is done properly, so that a system provides many years of use without problems. If you’re prepping for an install, call Septic Tank Pros Valdosta GA. Our partner technicians are experienced and committed to quality, so you can be sure the job is done right. Call (229) 415-7780 now.