Quality Ellenton GA septic system installers do a lot of legwork, long before a unit gets placed into the ground. A new unit will last years, and possibly even generations, if it’s placed the right way, but it can fail immediately if it’s not. On top of that, all Ellenton GA septic system installers must obtain a permit in order to execute the install, and may need to partner with city or county officials to show that specific tests were done in order to continue. These three assessments are essential first steps that should always be taken before any work or designs are done, and it may also be advantageous to perform them before you buy a property, so you can be assured that a tank and leach field will be permitted.
1. Pit
The pit test is very straightforward. In the course of this test, a hole is excavated and the soil is examined to establish its composition. A standard leach field is reliant on the soil’s composition to drain effectively. If there is a considerable amount of gravel or sand, your leach field should be capable to discharge the effluent (water) from the tank well, where the soil will finish cleaning it. If the soil has a considerable amount of clay or rock, it won’t drain well, consequently a traditional leach field will not be an alternative. If the site you’ve selected does not pass the pit test, you may be able to pick another site on your home or use an alternate type of drain field, like a mound system.
2. Perc
The perc, or percolation test, requires excavating a 14-inch deep hole, adding a 2-inch layer of sand or gravel, and then saturating it with water. The hole is generally left saturated for about two hours, and refilled as needed. After this, the hole is filled with 6 inches of water and observed for water drainage.
3. Visual
There are numerous things an inspector will check visually. The majority of units are gravity-fed, so they don’t depend on electricity or pumps to move effluent from the tank to the leach field. Because of this, the incline of the ground is crucial. An inspector will also try to find inclines that could possibly feed excessive water into the leach field, as well as nearby bodies of water, the water table, and distance from the proposed unit to things like the home and wells.
Enlist the Services of Quality Ellenton GA Septic System Installers Now
Selecting the right layout, type of system, and assessing the land effectively, are all important steps in making sure an install goes off without a hitch. Most significantly, these steps ensure that the install is done properly, so that a system provides many years of use without issue. If you’re prepping for an install, contact Septic Tank Pros Valdosta GA. Our partner specialists are skilled and committed to quality, so you could be sure the job is done right. Call (229) 415-7780 today.